CCSE 156-315.81 Syllabus Exam Questions Answers

Hybrid Emulation Mode is a mode of operation that allows load sharing of emulation between an on premise appliance and the cloud. Emulation is a process that analyzes files for malicious behavior by running them in a virtual sandbox. Hybrid Emulation Mode enables you to optimize the performance and scalability of your Threat Emulation solution by distributing the emulation workload between your local SandBlast appliance and the Check Point cloud service. References: Check Point Security Expert R81 Course, Threat Emulation Administration Guide

VPN Link Selection is a feature that allows the Security Gateway to select the best link for each VPN tunnel based on the network topology and the Link Selection configuration1. When the primary VPN link goes down, the Firewall can update the Link Selection entries to start using a different link for the same tunnel, as long as the remote peer supports this feature and has multiple IP addresses configured2. This way, the VPN tunnel can be maintained without interruption or renegotiation. The other options are not correct because:

Firewall

• A. The Firewall will not drop the packets, but will try to send them over another link if possible.

Firewall

• C. The Firewall will not send out the packet on all interfaces, but will use the routing table to determine the best interface for each destination.

Firewall

• D. The Firewall will not inform the client that the tunnel is down, but will try to keep the tunnel up by switching to another link.

References: IPSec VPN - Link Selection, Outgoing VPN Link Selection on a gateway with multiple external interfaces

The Correlation Unit in Check Point Security Management performs several actions, but it does not assign a severity level to the event. The Correlation Unit is responsible for identifying patterns in logs, marking logs that are part of larger patterns, generating events based on the Event policy, and adding new log entries to ongoing events. However, assigning a severity level to an event is typically done through the Event policy configuration, not by the Correlation Unit.

References: Check Point Certified Security Expert R81 Study Guide

The command cphaprob all show stat is not related to redundancy and functions. This command does not exist in ClusterXL or VRRP. The other commands are valid commands for checking the status of cluster members, interfaces, and synchronization. ClusterXL and VRRP are both high availability solutions that provide redundancy and load balancing for Check Point gateways. References: Check Point Security Expert R81 Course, ClusterXL Administration Guide, VRRP Administration Guide